Epoxology CanadaRequest an Assessment
Back to Learning Centre

Finish Selection

Slip Resistance And Floor Texture

Compare three resinous floor textures and learn what to specify for a washdown aisle or a garage that gets wet in winter.

Side-lit flooring samples showing three levels of surface texture
Illustration. Smooth, fine and more pronounced floor textures.

The Short Answer

Choose the finish for the conditions people actually walk in. Compare samples of the complete finish, then agree how the floor will be cleaned and how water or other contaminants will be removed.

Three Texture Profiles

Three schematic cross-sections showing a smooth finish, a fine-textured finish with shallow peaks, and a pronounced texture with taller ridges. Smooth finish Fine texture Pronounced texture Finished coating surface
Exaggerated side views of three finished surfaces. These profiles illustrate texture only. They do not represent measured slip resistance or a specified aggregate size. Open Full-Size Diagram
  • Smooth finish. Review it where routine cleaning is a priority and discuss how spills will be managed.
  • Fine texture. Compare a finished sample with the footwear and cleaning tools used in the space.
  • Pronounced texture. Ask how the proposed surface will be scrubbed and how residue will be removed from the low points.

Food-Processing Example: A Washdown Aisle

A packaging aisle is washed at the end of each shift. Staff cross it in work boots, and process residue can collect near the drain. The facility needs grip along the wet walking route and a finish the sanitation crew can clean with its existing equipment.

  • Map the wet zones. Mark where people walk, where residue lands, where rinse water flows and where it pools. Check the drain edge and the transition into the drier aisle.
  • Compare finishes under the same conditions. Review fine and more pronounced textures with the sanitation and safety teams. Have them compare how well their approved cleaning process removes representative residue from each sample. Use the samples to compare texture and cleanability. If the facility requires traction testing, agree on how the finished surface will be tested, including the method, wet conditions and acceptance criteria. Keep footwear, housekeeping and spill response in the plan.
  • Write the decision into the scope. If both finishes meet the specified traction criteria and one cleans more reliably, specify that finish for the walking route. Address any ponding in the drainage scope and record the approved texture, cleaning procedure and transition details.

See Floor Drains, Slopes And Cove Base for the drain, slope and wall details that go with the washdown finish.

Read The Food-Processing Flooring Guide

If you’re planning a floor upgrade in a washdown area or busy work zone, explore our industrial flooring services.

Garage Example: Wet Tires And Snowmelt

A homeowner parks two cars in winter and walks from the garage door to the house entry. Snowmelt follows the tire paths and pools near the threshold. Map the wet spots and the main walking route, then compare finished samples in the light and footwear typical of the garage.

Ask what texture and topcoat the installer will apply, how to remove salt and grit, and where standing water can be cleared. A sample can help you compare feel and cleaning effort. Ask separately what evidence supports any traction claim for a wet floor.

Review How To Choose A Resinous Flooring System

What To Confirm In The Quote

  • Name the finish, texture and any aggregate used, with an approved sample where practical.
  • Identify wet zones and any changes in texture between areas.
  • Record any required traction test method, surface condition and acceptance criteria for the specified finish.
  • Ask for written cleaning and spill procedures, including equipment and products compatible with the finish.
Does A Glossy Finish Tell You How Much Grip It Has?

Sheen describes how the surface reflects light. Ask about the actual texture and any test data for the finished assembly under relevant conditions.

Technical References

  • CCOHS Guidance On Preventing Slips, Trips And Falls
  • Sika Canada Example Of Variable Finish Texture

Related Lessons

Request an Assessment
Call +1 (905) 840-8405
↑