Epoxology CanadaRequest an Assessment
Back to Learning Centre

Repair And Renewal

Recoating Or Replacing An Existing Resinous Floor

Compare recoating, local repair and full removal before deciding what to keep on an existing resinous floor.

Prepared floor patch next to older resin coating
Illustration. A prepared patch beside existing coating.

The Short Answer

Find out what can stay before you price a new finish. Check where the existing coating is worn, where it is loose, and whether the proposed system can bond to the surface that will remain.

Three Ways To Renew The Floor

Three concrete floor cross-sections show a new coat over retained coating, a new coat spanning a repaired patch, and a new system applied after the old coating is removed. RecoatRepair selected areas and recoatRemove and rebuild Retained coating New coating Local repair Concrete slab
Illustrated cross-sections. Layer counts and thicknesses vary by system. Open Full-Size Diagram
  • Recoat. Consider this when the existing coating is sound and the installer can verify compatibility and adhesion after the specified preparation.
  • Repair selected areas and recoat. Remove unsound material from defined areas, address the underlying cause, and check that the remaining coating can accept the new finish.
  • Remove and rebuild. Consider broader removal when inspection finds widespread loss of bond or when compatibility cannot be established. Inspect and prepare the exposed slab before installing the new system.

Warehouse Example: Worn Forklift Lanes

A warehouse has scuffed turning lanes and two small areas of exposed concrete. Mark the worn paths on a plan and record forklift loads, cleaning methods, and closure windows. Ask the installer to check whether the wear is limited to the finish and inspect the edges of the exposed areas for loose coating.

If the surrounding coating is sound and a trial shows acceptable bonding, the quote may allow for local repairs before recoating. If inspection finds loose coating beyond the visible wear, ask how the scope will expand and how the affected lanes can reopen in phases.

Review Phased Return To Service

Garage Example: An Older Coating Of Unknown Origin

A homeowner inherits a coated garage with loose patches at the tire paths and no product records. Photograph both the loose patches and areas that look sound. Note recurring moisture near the door and any oil contamination.

Ask the installer to evaluate the existing bond and contamination and explain whether a representative trial patch can establish compatibility. If the old coating cannot be retained with confidence, ask for a removal scope and what slab checks are included before rebuilding.

Review Concrete Moisture Before Epoxy

What To Ask For In The Quote

  • Mark what stays, what gets removed, and the limits of local repair.
  • Specify surface preparation and how compatibility and adhesion will be checked.
  • Explain how moisture, contamination and joint damage will be investigated if found.
  • Document the backup scope, its effect on downtime, and when each type of traffic can return.

If you are still documenting symptoms, see Why Resinous Floors Fail.

Technical References

  • Sika Canada Guidance On Assessing An Existing Coating
  • Sika Canada Product Example Of Compatibility And Adhesion Trial Patches

Related Lessons

Request an Assessment
Call +1 (905) 840-8405
↑