Start With The Handover Instructions
Use the care instructions for the installed finish. Confirm the first cleaning date, approved products and equipment, then set a schedule for the traffic and spills your floor actually sees.
If the floor is new, review Cure Times And Return To Service before scheduling the first wash.
One-Page Maintenance Checklist
- Before The First Clean
Confirm the first permitted cleaning date, approved cleaner and dilution, and the approved pad, brush or mop. Record who handles cleaning and inspections.
- Daily Or Each Shift
Remove loose grit from entrances and traffic paths. Check for tracked water, spills and obstructions. Adjust frequency to traffic and season.
- When A Spill Happens
Keep people and vehicles clear of the area as needed. Follow the site spill procedure and use a cleanup method approved for the substance and finish. Remove residue and standing liquid.
- Scheduled Cleaning
Use the approved equipment and dilution. Clean edges, turns and other places residue collects. Follow the written procedure for rinsing and drying.
- Inspect And Record
Look for wear through the finish, loose edges, blisters or changes at joints. Photograph the area and record when it appeared. Ask for an inspection if damage spreads or affects safe use.
Warehouse Example: Forklift Traffic
A warehouse sees grit near loading doors, rubber marks at turning points and occasional drips from equipment. Have the shift lead check entrances and turning lanes at the start of each shift. Schedule the scrubber when the lane can be cleared, and adjust the schedule if grit or residue builds up between passes.
Ask the installer to confirm the scrubber pad or brush, cleaner and dilution, and any restrictions around joints. Follow the facility’s spill procedure for equipment fluids. If repeated marks clean off but a patch of exposed concrete grows, document both separately and request a coating inspection.
Garage Example: Winter Salt And Grit
Two cars bring in slush, salt and road grit. Remove loose grit before wet cleaning. Check the tire paths and threshold after snowy days, and remove standing meltwater using the method approved for the floor and its drainage.
Ask the installer which cleaner and tools suit the finish, whether the routine changes in winter, and how to handle oily spots. If peeling appears around a tire path or the threshold, take a wide photo and a close-up and note whether the area gets wet repeatedly.
When Cleaning Is No Longer Enough
Compare the area before and after an approved cleaning. If the coating is lifting, worn through or changing around a joint, have the installer assess the condition before trying a stronger cleaner or abrasive pad.
See Why Resinous Floors Fail for what to document and Recoating Or Replacing An Existing Resinous Floor for repair options.
Technical References
- Sika Canada Cleaning And Maintenance Guidelines
- CCOHS Guidance On Spills And Walking Surfaces

